Route Planning
We agree the cable route first, so cables follow walls, trunking or ceiling voids instead of crossing open spaces.

Neat wiring and a safe power connection for every camera
In Brief
CCTV cabling and power is the wiring that connects each camera to the recorder and to a power supply. Good cabling is tidy, protected and correctly terminated, and the power connection is safe, because most CCTV faults trace back to poor cables, loose connectors or bad power.
Cameras get the attention, but the cables behind them decide whether a system works reliably. Each camera needs a route for its video signal and a source of power. Depending on the system, that is a network cable that also carries power, a coaxial cable with a separate power lead, or a wireless camera that still needs a power source. Whatever the type, the cable needs protection, proper terminations and a route away from damage.
We plan the cable routes before drilling, run and fix the cables neatly, connect the connectors and power supplies, and isolate power before any electrical connection. This is useful for a new installation, for tidying up an exposed or messy older one, or when a camera has stopped working because of a cable fault. Cabling and power sit alongside our electrical works and our CCTV installation service.

We agree the cable route first, so cables follow walls, trunking or ceiling voids instead of crossing open spaces.
We run and fix the cables neatly, protect them where they pass outside or through walls, and hide them where the structure allows.
We fit and check the connectors so the signal reaches the recorder cleanly and no joint is loose.
We connect the power safely, with the supply isolated before any electrical connection and adaptors placed sensibly.
We protect outdoor runs and joints from sun, dust and moisture, which commonly cause faults on exposed cameras.
We can neaten exposed or messy cabling and replace damaged cables on an existing system.
We look at where the cameras and recorder are or will be, and where cables can run with the least visible wiring.
We isolate the power before any electrical connection and prepare the routes before fixing the cables.
We run and fix the cables, fit the connectors, and connect each camera to the recorder and power.
We check each camera's picture and power and confirm the recorder is saving footage.
Every property is different, so we confirm the price before any work starts. These are the things that most often change the time and cost.
Often, yes, using trunking, ceiling voids or routes inside walls where the structure allows. Where full concealment is not practical, we run cables neatly and protect them.
Common causes are a damaged cable, a loose or corroded connector, or an overloaded power supply. We trace the fault and repair it. See CCTV repair for what that involves.
Low-voltage camera power is simpler than mains wiring, but only a qualified electrician should make a connection to the mains supply. Our electrical works team handles that.
Often, yes. We check whether the recorder has spare capacity and whether the cabling can reach the new positions, then confirm the price before starting.
No. We can repair, tidy or extend the cabling of an existing system as well as cable a new one.
Get a free quote today and let our expert technicians bring reliable CCTV cabling and power to your Dubai property.
Get a Free QuoteTell us what you need and we'll get back to you with a clear quotation — no obligation.