Surface Preparation
We clean, repair and make sound the floor and wall surfaces so the membrane bonds properly.

A membrane under the tiles so water stays where it should
In Brief
Bathroom and wet area waterproofing is applying a waterproof membrane to the floor and the lower part of the walls before tiling, so water cannot soak through the tiles and grout into the structure. It matters most in showers, but also applies to kitchens, laundry rooms and other wet areas.
Tiles and grout are not waterproof on their own. Water passes through grout lines and tile edges, and in a bathroom that water can reach the screed, the slab and the room below. A waterproof membrane under the tiles stops this, so the water runs to the drain and not into the structure. Without it, a small amount of water over months can cause stains, mould and damage that show up on the ceiling below.
We prepare the surface, treat the corners, joints and the area around the drain with extra care, apply the membrane to the floor and up the walls to a suitable height, and test the treated area before the tiles go down. If an existing bathroom leaks, our bathroom leak investigation finds out whether the cause is a seal, a fitting or failed waterproofing. After waterproofing, our tiling team can finish the surface, and the wider service is on our waterproofing page.

We clean, repair and make sound the floor and wall surfaces so the membrane bonds properly.
Wall-to-floor corners, joints and the area around the drain are detailed with extra care, since these are the weak points.
We apply the membrane across the floor and up the walls to a suitable height, and higher inside the shower.
We seal the pipes, outlets and fittings that pass through the membrane so water cannot track along them.
We test the treated area before tiling, so we find any weakness while it is still easy to fix.
We plan the waterproofing together with the tiling, and fix the tiles once the membrane has cured.
We look at the room, the floor and drain, and any signs of previous leaks, and agree the extent of the work.
We prepare the surfaces and detail the corners, joints and drain before applying the membrane.
The membrane is applied to floor and walls and left to cure as the system requires.
We test the treated area and, once it passes, the surface is ready for tiling.
Every property is different, so we confirm the price before any work starts. These are the things that most often change the time and cost.
Yes. Tiles and grout alone do not stop water, so a membrane under the tiles is what keeps water out of the structure, especially in showers.
Usually not reliably. The membrane has to go under the tiles. If the old waterproofing has failed, the tiles generally have to come up.
The membrane must cure first, and then we test the area. The time depends on the system, and we tell you when we confirm the work.
Yes. We treat shower walls higher than elsewhere because they take direct water, and the shower floor and drain need extra care.
They can, especially where there are floor drains or a lot of wash-down water. We advise on where it is worth doing.
Get a free quote today and let our expert technicians bring reliable bathroom and wet area waterproofing to your Dubai property.
Get a Free QuoteTell us what you need and we'll get back to you with a clear quotation — no obligation.